In my attempts to print at 0.1 mm/layer (i know, i know, it's not recomended with a 0.4mm nozzle) I've run into a slight problem. One side (right side) of the print is coming out with a weird looking gash in it!
Not sure what's causing the gash, if it's too much or too little plastic, but it sure is annoying... It seems to start small, then get wider and wider as the print progresses.
the part I'm currently printing is a 1cm^3 (1 centimeter cube)
Here's a picture of the problem:
No comments:
Post a Comment
I always love hearing new ideas! Post here if you have some, but beware, posts that seem like spam probably won't get past moderation.